Q&A ROUNDUP

Orbit™ Bare Fiber Coning and Chisel System

April 2, 2020, 5:42 p.m.
Q
Is this coning device capable of creating a cone with a flat tip on up to a 2,000um POF?
A
Yes, this geometry can be formed on a tip of a fiber using the Orbit system.
Was this helpful? 11 0
April 15, 2020, 3:22 p.m.
Q
Can this system be used to create just an angled flat facet on a fiber tip?
A
Yes. The standard angle range is 0 degrees (flat tip) to 50 degrees referenced off the vertical.
Was this helpful? 4 0
April 2, 2020, 6:20 p.m.
Q
Is this coning device capable of creating a cone with a flat tip on up to a 2,000um POF?
A
Yes
Was this helpful? 2 0
Sept. 22, 2023, 8:16 p.m.
Q
We have a orbit bare fiber polishing system but the holders we have on accommodate a 125um polyimide to 155um. Now we are using a 125um fiber coated with single layer acrylate bringing dia up to 175um. Do you offer chisel tip fiber holders that will fit a 175um fiber?
A
Yes, we can fabricate Fiber Adapters for fibers with diameters from 80um to >2mm. We will send you a quotation for a 175um Fiber Adapter.
Was this helpful? 1 0